Hey guys and gals. I just recently finished my complete restore of my Twilight Zone. It looks and plays fantastic. I just have a couple of questions. I put on new cabinet decals and noticed a couple of things. First of all I was super careful putting them on and everything went well. However after I was done and waited a full 24 hours to install the legs (with leg protectors) I when I went later to change out my legs that there was some minor wrinkling in the decals under the protectors. Nothing that can be seen with the protectors on but none the less I was surprised and disappointed and curious is this a known issue with new Gen 2 cabinet decals from Planetary Pinball?Also should I put some mylar cabinet button protectors on to prevent wear there or do these decals not need that? Also one last question, my TZ slot switch is hammered all the way back and I know this is VERY common even though it only has 30 or 40 games on it! Anyway my question is , is it o.k to put one of those enhanced TZ slot switches from PBR ? Or will it pull on the screws under the playfield? Or is there any other solution to this issue? Sorry for the long post and thanks in advance for any assistance.