Glad to hear finally available. Ordering.

Received in 6 days.
Nice work.

IMG_20190322_121033_01 (resized).jpg

Yes

15534524474131497663071 (resized).jpg

I'll post a few pics as I go.

1553454074290285582154 (resized).jpg

Good eye, Chris. I will look into my options tomorrow. I'm quite surprised, because even the dimples on this pf have been spot on.

That's right, they are not centered in artwork.

15535277054811388179427 (resized).jpg

But the lower hole is 1/8" to high. I have contacted Mirco, so he is aware.

15535277765651198452421 (resized).jpg

I will oval the hole and use larger standoffs at bottom of both sides.

1553527933228150518854 (resized).jpg

Haha. Because I am an idiot..

Of course, I will set final location according to flipper.

That's what I'm using..

Used a chain saw blade file to oval the hole.

IMG_20190325_114028469 (resized).jpg

Took a little less than 1/8" to get it right with flipper.

IMG_20190325_153159241 (resized).jpg

And large stand off covered and looks right.

IMG_20190325_153208495 (resized).jpg

A nice touch I noticed on these is the bevel on all holes where post or screw going. Eliminates possible pulling up of clear coat for those who might not do this on their own.

IMG_20190325_153309889 (resized).jpg

I flattened the points on a t-nut so I could adjust final spot in the oval I made. Once I got the oval where I needed, I went back to pointed t-nut.
It's not moving.

And done.

IMG_20190409_211557_01 (resized).jpg

Painted the cabinet too. Luv thus machine

IMG_20190407_174802_01 (resized).jpg