So for those that got the TAF glass, my original trim on the glass/translite will not fit the thickness of the new Glass. What are you using as a replacement lift channel, and trim?
You're currently viewing posts by Pinsider Talon2000.
Click here to go back to viewing the entire thread.
Quoted from metahugh:I am using the original lift channel and side trim but I put a few spots of friction tape to keep them from moving.[quoted image]
Well considering that I can't even get the original trim to fit, I'm not going to be able to get tape in there as well. The cpr glass is almost double in thickness to my original glass and translite.
Original glass is .125 inches, repro is .160 trim is .120 with the notch for the translite, the trim is very tight on the original glass.
Quoted from metahugh:How thick is your original glass? How wide is the lift channel?
I have two sheets of translite glass and they both measure just about the same at 0.128” thick.
[quoted image][quoted image]
The inside of my channel is 0.153” in width.
[quoted image]
It sounds like you either have the wrong lift channel or are comparing the wrong thickness glass.
So the trim you had on your TAF must have been very loose before you swapped it over to the thicker glass. Mine is the original glass trim so it's definately not wide enough to fit the new glass. Now to figure out which trim to order. Because the new trim I ordered was the same as the old. Guessing I will have to go with a WPC95 trim since that should be thicker because of the lightboxes on those machines.
Quoted from metahugh:So our glasses are basically the same thickness but my lift channel is wider than yours. I am using trim I bought from Pinball Life within the past couple of years.
The trim on mine wouldn’t stay on the CPR glass without the grip tape.
You're currently viewing posts by Pinsider Talon2000.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/new-backglasses-added-at-cpr?tu=Talon2000 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.