You're currently viewing posts by Pinsider Completist.
Click here to go back to viewing the entire thread.
Sounds like you are off to a great start. Nothing worse than spending all that time and effort swapping everything over and not bothering to clean stuff. Also good call on the T-nut jig. my number 2 tip behind removing the clear before screwing into the pf...
Dimples should be considered as suggestions only. Always test fit before drilling the holes, and yes you should pre-drill them. Use a drill stop when doing the bottom side to prevent going through the top and ruining yr gorgeous new pf.
Yes you can wax a cleared pf. And the easiest time to do it is before you start to populate the top side.
You're currently viewing posts by Pinsider Completist.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/need-help-with-first-playfield-swap-mirco-cftbl?tu=Completist and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.