Quoted from PinDeLaPin:player 6 scoring 1 point in 2nd frame only.
If it only happens in the 2nd frame then I would recheck the 2nd frame relay for a switch that is possibly gaped too close and being set off by vibrations.
(Topic ID: 246595)
You're currently viewing posts by Pinsider EM-PINMAN.
Click here to go back to viewing the entire thread.
Quoted from PinDeLaPin:I thought it would just be done in a few minutes but it turned out to be a major pain in the ass. There was very little give on that little plate that the fuse's mount too and it was hard as hell to get my soldering iron in there and also on the secondary outlet that the white wire went to it was the same story on that. A little 10-minute job turned into 2 hours but hey at least it's done now and it works that's all I'm concerned about
Power cords are never a 10 minute job when done the right way. Looks easy, basically easy, yet very time consuming. Nice work. 
Quoted from PinDeLaPin:Ok Tim I decieed to try a 2 player game since all I have been doing is testing in 1 player mode. Right away I knew I had a problem as the 2nd dime didn't light up the 2 on the backglass. Then as soon as I played a frame it never went to player 2 and instead went to frame 2 of player 1.
I would check your Player Unit by hand. Does the stepper move freely advancing and resetting? If not you need to tear it apart and service it.
Check your "Player Reset Relay" for a switch not adjusted correctly, if you have one. Also if you have a "Reset Relay."
You're currently viewing posts by Pinsider EM-PINMAN.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
