After having problems with the hold power on my flippers I realized that I used an older wiring harness from the transformer to the power supply. I was wondering if someone can take a pic of their data east power supply connector (the wire side) CN1, specifically pins 10 & 11. I am trying to see if there are 2 wires going to each pin. This would apply to any data east game after phantom and before Jurassic park. Thanks!

It is! But it only adds to my confusion. Do you know if the gray wires from pins 10 & 11 lead to the transformer or the flipper board? Thanks so much!

That would be awesome. Mine does go to the transformer. The book says the flipper board wires go to those pins. Wires are the same color too. Could you trace the wires from your flipper board, cn2, pins 6&7? You are a huge help in all of this. Thank you!

Thanks so much! I think I am completely missing that harness. So I'm guessing that is spliced into the wires that hit the transformer and cn1 pins 10&11? I can probably splice in? This was huge btw. Thanks for taking the time to trace that out. A lifesaver.

you're my hero! Thanks again! Before I realized the harness was different, I was killing myself trying to figure out why I had no 9v at the flipper board. Thanks again!!