You're currently viewing posts by Pinsider MoSeS_1592.
Click here to go back to viewing the entire thread.
I need a nylon gear roughly a half inch wide (i think 22 teeth) replicated since the teeth on the original are stripped. Does anyone know of a service (or does anyone here have the equipment and know-how) that could measure the gear dimensions, replicate it in CAD software and print it? How much would this cost?
Thanks!
Quoted from PinMonk:How complicated is the gear? Just a disc with teeth? Or, does it have cutouts and varying heights in the middle?
The gear is a perfect circle, the one side is melted.
20190522_140625_resized (resized).jpg20190522_140636_resized (resized).jpg20190522_140654_resized (resized).jpg20190522_140659_resized (resized).jpgYou're currently viewing posts by Pinsider MoSeS_1592.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/need-a-gear-replicated-with-3d-printer?tu=MoSeS_1592 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Cleveland, OH