Pull balls out. Put into switch edge test. Roll balls one at a time into the out hole and watch the switch count down.
(Topic ID: 146097)
You're currently viewing posts by Pinsider taxman.
Click here to go back to viewing the entire thread.
Quoted from ATLpb:ok left it on for over an hour and finally switch 36 went off. I don't have the book, thoughts?
Well, 36 is column 3 row 6. The switch itself is Center Ramp Opto. But guess what else is on Colum 3?
31 - Trough Eject
32 - Trough Ball 1
33 - Trough Ball 2
34 - Trough Ball 3
35 - Trough Ball 4
So, I'm going to stick with connector / cold solder joint. But I'm going to include the possibility of a failing diode.
Promoted items from Pinside Marketplace and Pinside Shops!
Robbinsville, NJ
You're currently viewing posts by Pinsider taxman.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
