Quoted from tuffano:Man, broken set screws are a pain in the A...
that's putting it mildly...
You're currently viewing posts by Pinsider ccotenj.
Click here to go back to viewing the entire thread.
Quoted from tuffano:Man, broken set screws are a pain in the A...
that's putting it mildly...
Quoted from stashyboy:I've only had that happen once. Back when I was using screwdrivers to adjust those set screws. I think they can torque the screw heads off center more likely to cause this problem. Since I've been using nut drivers, no more problems. You can put much more force on the screw where you want it-in proper alignment.
i learned that lesson the hard way....
@the op... it probably isn't a good idea to use wd-40 anywhere in a pin, even for this... a little bit of overspray or dripping could result in a very bad thing...
You're currently viewing posts by Pinsider ccotenj.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/my-project-sure-shot-a-larger-case-for-the-purity-police?tu=ccotenj and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.