If its not one thing it's another with my pin. Here is what's wrong

1 My kicker on the battlefield will not work even in test mode. I put my MM up to the coil and got 6.9 ohms. Is that right?

2 my GI will not light behind the right ramp under the wall plastic.

3 I do not have any flashers anywhere in the game. When I turn the game on one flasher in the back glass and one on the playfield stays on until the game boots up.

I checked all the wires no cuts anywhere and they are connected tightly to the board. Thanks in advise for the advise and help.

Thanks for the advise. I checked all the fuses on the driver board all were good. It's a rottendog board. I did replace the connectors at j120 and j121. I'll try resetting the cables and see if that works.

I pulled the fuses to check them they all work. To tell the truth Seal I got it from a place where i used to work. and its was in storage for a long time. everything was dirty and I diden't want to plug it in before a good cleaning cause a couple of the connectors were burned. do you think it could be the board? but all the other coils and GI work.

I checked all optos are working good. The coil is wired nice and tight. I'm thinking all my problems are on my rottendog board.

Thanks for the advise Chill. I doubled checked all connnectors by both looking at the manual and unplugging then replugging them in. I'm gonna try another board. hopefully that will fix everything.