Quoted from beltking:

For those with medieval and attack from mars, is it worth picking up monster bash or is it too similar and gets old? At the arcade it’s hard to tell if it’s a keeper or not.

Quoted from beltking:

I’m looking for an le if anyone is selling around Ohio. Keep missing them. ☹️
Guy I know has one with 100 plays but wants 15k which I think is too much.

Quoted from LTG:

Page 2-28 and page 2-29 in the manual.
https://www.pinballlife.com/monster-bash-slide-roller.html?Category_Code= bushing.
3/16 E ring. 7/32 X 7/16 18 gauge washer.
LTG : )

Quoted from LTG:

Broken wire or solder joint at the coil lugs, and dig around the thin wires from the coil windings to the coil lugs, easy to have a crack or break you can't see.
Less common bad coil, issue inside the wrapper you can't see or fix.
You could swap left and right flipper coils, but if you get that far I'd just replace the coil.
LTG : )

Quoted from LTG:

Scrape, sand, file, hold gently with a pliers and pull. Heat up with a soldering iron and try flux to get solder to stick. Etc. Etc.
LTG : )

Quoted from LTG:

I usually add them to an order so I have them on hand.
Planetary Pinball Supply, Pinball Life, Marco Specialties.
LTG : )

Quoted from LTG:

No. But then because of not finding them, haven't looked for years either.
LTG : )

Quoted from LTG:

Depends on your tools. And which one, you might have to remove the wireform over it, or at least loosen to get out of the way to remove the two screws holding the pop bumper cap on. 11/32nds nut holds them down over slingshot plastic. Remove the pop bumper cap.
I use a 5/16 nut driver below the playfield. Two nuts on the pop bumper ring rods. Yours are snapped off, hold what's left with a vice grip to remove the nut. Should be a couple washers too.
Slide the busted pop bumper ring up and out. Slide the new one in. Below the playfield fiddle around and line up the holes on the metal yoke and fiber board yoke that hooks to the plunger. Stick the washers on then the nuts. When you fasten the nuts, finger tight is good enough. Over tighten bends the rods and they break off prematurely.
Half hour should do it.
LTG : )