I had my first test report issue. Frank table down quit working. Checked it out and both screws were very loose. Tightened them up and back in business. Decided to do some other work. Added the spring washer to coil for scoop and got things nice and tight. I had at least 50 ejects and none went down the middle. Hopefully that is the end of that. I noticed a loose connection that needed tightened. I am surprised it was making contact. Also found a small screw at the bottom of the machine I couldn't find where it went but I have it in case I find it.
Next issue was my right orbit. Pretty much every ball hit dracs feet but went to the left flipper so I left alone. Now I wanted to get things working as they should. I tried raising the right side. I think I have it working well but still get some off the feet. Are the real slow ones still supposed to hit his feet? Is it just the clean shots that go with speed that are supposed to go straight to the right flipper? I did some searching and found some dracula's for sale that had cut feet for $50. Does that work. Seems like it would if enough was cut off. Any thoughts on this?