Monster Bash
Williams, 1998I just picked up the game and the table isn't going up or down. All 4 switches work (2 for the target banks and 2 for Franky). I can manual move the gears and they're not froze up and the table and targets have moved up and down but not during gameplay. I have a feeling it's not set to the correct position to start a game. Any help would be appreciated.
AAAA (resized).jpgAAAAA (resized).jpga (resized).jpgaa (resized).jpgaaa (resized).jpgQuoted from Yesh23:It wasn’t doing anything in the game or test. I moved it manually a few directions and it worked in the test mode but then it seems like it’s out of position
I'd try a separate power source on the motor. See if it works. Rule out a dead field on it. Then go over the mech. Anything binding above or below, anything metal on metal needing a drop of oil ?
LTG : )
Those DC motors will run slowly off a 9V battery. Turn the game off and see if you can get the motor to move to rule out the motor.
Make sure you have 12vdc on the red wire on the motor, and if so run a ground wire to the black wire. Motor should run. If not, bad motor. The switches don't have any effect on motor operation in test mode.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/monster-bash-franky-table-not-going-up-or-down?hl=ronkz650 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Indian Land, SC