Quoted from pbjksb:Hi, can shaker be added to 1998 Williams MB? thanks
Not supported in Williams software.
There has been kits that you can make a target or something trigger it for games like this.
LTG : )
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Quoted from pbjksb:Hi, can shaker be added to 1998 Williams MB? thanks
Not supported in Williams software.
There has been kits that you can make a target or something trigger it for games like this.
LTG : )
Quoted from 2pupPinz:I’m thinking there is a menu setting
I'm not sure if there is one or not.
A factory rest might help.
LTG : )
Quoted from LTG:I'm not sure if there is one or not.
A.2 24 Phantom Flip on or off
U 12 Reset Phantom Memory ( game has to relearn it then )
LTG : )
Quoted from 2pupPinz:does it take some time/plays before it becomes enabled?
Yes. At least ten games I'd think.
LTG : )
Quoted from Zitt:No idea how one goes about adjusting these.
Carefully bend the bracket up or down as needed. A tweak or two should do it.
LTG : )
Quoted from rx3:I replaced the switches,
The sign of a switch with flux inside. Works in test, but slow so it often fails in game play.
LTG : )
Quoted from Kobaja:Can someone please post an original MB with a knocker installed? I dont know what to wire it to.
Tests - Coils - Stop on knocker - hit start button - then the "+" or "-" this steps you through coil, drive transistor, fuse, wire colors, connector number and info for which pin the wires go to.
LTG : )
Quoted from Jimmyhonda:Any solution for this?
Lower flipper strength or increase pitch of the playfield.
LTG : )
Quoted from Jimmyhonda:So flipper strength can’t be lowered.
Sorry. ( weaker flipper coils )
Raise or tweak wireform so it's banked a little.
LTG : )
Quoted from Jimmyhonda:What do you mean by “banked”?
Think race track for fast cars. Corners are banked to allow higher speeds through the turn. Outside edge higher than inside edge.
LTG : )
Quoted from Williampinball:U should test them coils too see if they work in test first
He's done all that.
I last suggested checking common wire at the coils it all goes to for a break. Red wire brown stripe, page 3-6 in the manual.
LTG : )
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/monster-bash-club?tu=ltg and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.