Monopoly electric company kick out not kicking out strong enough. Stays in hole. Is the coil weak? Or need new sleeve?

Relplace coil sleeve and cleaned parts. It trys to kick out but does not kick out over the small metal bar in front of hole. I have tried repositioning coil bracket but bolt holes allow very little movement. Was thinking of drilling out holes on bracket too allow more adjustment?

Not positive . Was in the machine when I got it. Will check

It is the correct coil. Parts were cleaned. Still not ejecting properly . Replace coil?

I have replaced the sleeve. Aligned properly.. Still not kicking out. Is it possible the out hole has worn down a bit in front of the metal bar in front of ejection point? It seems too kick out right into bar popping it straight up rather than over the bar. I am goin too order another coil too elimate as possiblilty.

Bump