Monday Night Football
Data East, 1989You're currently viewing posts by Pinsider nvu4prod.
Click here to go back to viewing the entire thread.
Quoted from dirtbag66:Question for all you MNF owners:
Does anyone know the size of the brackets used to hold the referee topper? Have one coming from Marco, but it doesn't include the "L" brackets. Thanks in advance!
My brackets have been riveted. The dimension of the brackets are 1" on the plastic topper by 5/8" flat to the backbox.
Hope this helps!
MNF.JPG.pdfBoth wires at the end of the fuse are grey/green stripe. the right side has two wires going to the left and right flipper coil lugs. the left side has one which
is in a cable loom. Not sure where it ends up, not able to pull the game out to access the backless to see where it lands. Looking at the schematic from the manual, I see Grey/Green going to CN-11 pin 6 SOL. Drive 5 at the CPU board to J-1. Perhaps someone with more skillset will chime in!
MNF1.jpg.pdfMNF2.jpg.pdfQuoted from Isochronic_Frost:There are so few MNF’s I don’t know if there will be big demand. That would be great if repros of the ramp were available
I agree! I would certainly be in on a repro ramp if they were available.
You're currently viewing posts by Pinsider nvu4prod.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/monday-night-football-club-it-s-good?tu=nvu4prod and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Cupertino, CA