You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Quoted from jrawlinson_2000:We have tried covering the ball launch coil in electrical tape,
Please try a new coil.
Quoted from Jon9508:Also sometimes when I boot the game up a get a communication error(thought it was the cat cable but it's not that)
Reseat the cable on the playfield and in the backbox.
LTG : )
Quoted from jrawlinson_2000:I would ask why,
To keep eliminating things. Like a coil with a flaky internal short.
Quoted from jrawlinson_2000:I did wonder why CGC asked to cover the ball launch coil in electrical tape,
To be sure the lugs of the coil weren't coming in contact with the lockdown bar receiver.
LTG : )
Quoted from pinballaddicted:we keep blowing a 12V MOSFET.
Does your game have the three driver boards under the playfield ? If so I'd swap the bad one with another one. Then if it happens again in the same driver board spot, you'd know the issue is out in the game and not on the driver board. If the 12V MOSFET blows again in a different driver board location, then you'd know it's on the board.
LTG : )
Quoted from pinballaddicted:the MOSFET is located on the large green PCB
Damn.
Have you talked to Ryan at CGC or the engineer about this ?
LTG : )
Quoted from gpa_joe:I wonder if a new driver board will fix the problem or just be a temporary fix until the main board gets replaced?
Open a ticket on the website so the engineer can look into it.
LTG : )
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/mmrle-blows-fuse-f1-on-the-board-to-the-right-of-coin-box?tu=ltg and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Hopkins, MN