Hey hey folks. I'm sure you get this here a lot but I figured it couldn't hurt: If anyone is looking to move their MMR, please let me know. TIA.

Joined the club with this beautiful 2017 Classic courtesy of Michael at Flipper Fidelity! Time to run through this thread a bit to see if I can beef up lighting and if I'm running correct code (some sounds seem off). But it plays like a dream and is already more than we hoped for. Got to Royal Madness last night and drained on the last shot - so so fun.

20201119_094724 (resized).jpg

So it looks like I'm running code 2.0.2 on my Classic, but current software is 3.0.0 (with 2.0.2a in between). Does the Classic support 3.0.0? I've never purchased a pin that needs an update and want to make sure I don't screw it up.

Having an issue with our early build MMR standard. Both the catapult and moat solenoids decided to stop firing today. I don't see anything obvious when lifting the playfield - any thoughts/assistance appreciated.

Sorry it took a couple weeks to circle back to this - back injury kept me down. From the solenoid driver problem I had above, there's some kind of issue with CR2. The fuse was blown so I replaced it, and after there was no LED on. Touched a wire near it while pointing out the area to my wife, then the solenoid went and the fuse blew quickly. Replaced again, fired up the machine and the LED went on for a second, solenoid fired, then the fuse blew.

Any help greatly appreciated.

16356408496008185205300691455766 (resized).jpg

Apologize, I am new to pinball maintenance. Are those the three-pronged parts on the board there? And if so, what am I looking for to see if they are blown?