Can you post a picture and list of parts you used for the spots. I would like to do the same.

I had the same issue. It's in the castle.

https://pinside.com/pinball/forum/topic/mmr-help-id-this-part-found-at-the-bottom-of-the-cabinet#post-2845946

So upgrading an MMR LE is about the same price as buying a royal edition.

If I did not want to upgrade and buy a royal mmr how much is a HUO MMR LE going for nowadays?

We're any pics posted of the black sparkle powder coat?

Did they add protectors to these new models? Or will we have to order cliffy and mantis protectors.

Any recommendations on which are the best to be ordered or what combination ? (if necessary)

Mine was way off and would not close. I removed the castle front and then removed the door (only two screws) then elongated the screw holes about 3/16 of an inch with a round file. Reassembled moving the door to the right of the elongated holes. See Pic of before.

20200510_184525 (resized).jpg

Having an issue with my Royal MMR.

About 15 to 20% of the time when the catapult launches the ball it hits the switch at the top of the ramp (behind the castle) . When it hits the switch it slows the ball down or it may even bounce off the switch and roll back.

I went in the settings to lower catapult power but it's on default. The only other options are +1 and +2 which would make it too strong.

To stop the ratttle on my MMR royal I cut some plastic shims using .20 thick (1/2mm) plastic. The shims about 1/4 inch wide by 2.5 inches. I then tucked them between wood cabinet and bottom of the plastic trim. About three or four on each side. This seemed to raise the glass enough to stop the rattling.

Did the same on my AFMr but used .30 inch thick plastic. About the thickness of a credit card.

Pictures are before they are tucked under the plastic. Also used black sharpie to hide white plastic edges.

20200601_192648 (resized).jpg20200601_192740 (resized).jpg20200601_192918 (resized).jpg

Same as what I got but the two screws were to short to screw the plate to the cab. Had to get longer screws.

I also did not get metal washers under my MMR royal slingshot plastics like I did on my MMr LE, AFMr LE, and MBr LE.