Can you use Stern or Coin taker shaker motors in MMR or doest it use a proprietary set up?
You're currently viewing posts by Pinsider goalie.
Click here to go back to viewing the entire thread.
Quoted from Only_Pinball:I had the exact same post snap. What I did was this, I took the broken part to Lowe's and used the template to find the thread pitch. Then I found some threaded rod with same pitch. The smallest one they have was about 1/4" longer so I just screwed it into the T nut so the extra part sticks out under PF. Sorry I don't remember the size but I was able to find what I needed in 5 min and was back playing. Hope this helps!
Thanks, I think I found the correct part. 02-4425-1 Post stud 8-32 x 2-3/8 inches 5/16 drive. It looks like the correct size and Marco shows MM compatibility.
Has anyone changed out the castle spotlight bulbs? I just tried to swap mine out for somethign brighter but it looks liek the ones that come with the machine are glued into the bulb socket.
Another issue is my Trolls don't register hits, they have hove be super hard hits in order for them to register. Probably 2 out of 10 hits work.
Quoted from Lermods:I put green spots in my game. Your leaf switches likely need adjustment or trolls aren't on good/binding.
Were your bulbs glued into the spot sockets?
So my left Troll stopped working. I get the Error Check switch 45 UPF. Wires look fine, the troll face is not stuck or anything like that.
Quoted from LTG:Go into Tests - Switch Edge - see if the switch below the playfield that lets the game know the troll carriage is up or down works, and see if the troll face switch registers or is stuck closed.
Then follow the coil wires to a nearby driver board. Along one edge is ten pins that plug into the huge board below the playfield, push on them to be sure they are seated good.
LTG : )
Thanks, Lloyd.
Does anyone know where I can get new cabinet side art? My MMR just got delivered with a big scratch that happened during shipping.
Don’t the bolts on the side hold the playfield hinge/rail hardware? I don’t think there’s anything else holding up the playfield if I remove those.
You're currently viewing posts by Pinsider goalie.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/mmr-owners-club-all-things-mmr-discussed?tu=goalie and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.