Medieval Madness
Williams, 1997You're currently viewing posts by Pinsider Pin_Guy.
Click here to go back to viewing the entire thread.
I have no idea why folks are even talking about the DMD when the game is obviously stuck in reset based solely on the single picture of the CPU board that shows the blanking circuit is activated. 
So far the only good advice I've seen is to remove the ribbon cables from the CPU to see if it can complete the boot cycle as failures on other boards can cause the blanking circuit to activate as a protective measure.
You're currently viewing posts by Pinsider Pin_Guy.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/mm-wont-start-since-reassembly?tu=Pin_Guy and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Northfield, MN