You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
I'm telling you, W13 is not necessary. It's removed on both of my Creatures. And I've seen plenty of MPU boards that never had W13 installed.
A zero ohm resistor *is* a jumper. The boards were assembled by a machine. A machine cannot place a wire jumper, but it can place a resistor.
Quoted from donjagra:I don't usually clean off the flux either...
Nooooooooo! You *must* remove flux! Kittens die if you don't!
I sent him new sound ROMs already. He had problems with the original and the new sound ROMs, so I think it's safe to rule out the sound ROMs.
The sound is way off on that game. Missing music, wrong sounds playing at the wrong time.
You've swapped sound boards between TAF and CFTBL too, right?
I wonder if something is corrupting data lines between the CPU and sound board? You've changed the ribbon cables, correct? Maybe the fliptronics or dot controller are shorting data lines somewhere along the way?
Pull it out and have a close look at the back side, any solder globs connecting 2 pins of the ribbon cable?
You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/missing-music-on-cftbl?tu=johnwartjr and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.