Isn't that the opto that screws into the top of that rail on the back side? If so, can you use a washer to lower it?
That looks like a brand new game, as such you should contact your distributor as well before doing any modification.
You're currently viewing posts by Pinsider 85vett.
Click here to go back to viewing the entire thread.
Isn't that the opto that screws into the top of that rail on the back side? If so, can you use a washer to lower it?
That looks like a brand new game, as such you should contact your distributor as well before doing any modification.
Do you have some deadfoam or a cutoff wheel?
I'm guessing the angle with the washer was because the washer was slightly larger than the base of the opto. If so, cutting one side flat should cure that. If not comfortable doing that you could use some deadfoam on the bracket and then screw it back in till it lines up. The foam will compress but is thick enough to where it will hold it's placement over time.
You're currently viewing posts by Pinsider 85vett.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/misaligned-opto?tu=85vett and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.