Became a millionaire (owner) today so happy to join the club

The game I bought is a project to say the least:
-Biggest issue seems to be the roulette table. While it does spin, the switches are not in the middle of the holes. I'm guessing part of the assembly is loose.
-The insert (?) of the roulette is not flush with the playfield. Anyone got an idea on how to adjust that?
-Right bottom display is outgassed. Have one laying around so that's okay.
-Several inserts are missing their text. Are these available somewhere?
-Slingshots and popbumpers not working. Other coils are sluggish.
-It needs a good clean and fresh rubbers.

Gonna be fun!

20211230_143354 (resized).jpg

Does anyone have a photo of what the roulette wheel is supposed to look like? Pretty sure the 2 screws in my game are not original.

20220120_192307 (resized).jpg

Thank you very much!

Adjusting the pcb switches seems to be nearly impossible.. There's such a fine line between working correctly and not working correctly..
The pcb board and ball wheel are not 100% parallel, that's what makes this really hard..

Sorry for the triple post, but I've managed to fix it!
The diameter of the hole in the bearing/ball wheel is a lot bigger then the diameter of the shaft of the motor.
At first I tried placing something in the gap, but I never got the wheel and pcb board flush

My fix: found a washer with a smaller diameter, drilled two holes in them and put the 2 screws through it. Like a poor mans version of the one Gesj5 made. Thanks for the inspiration!

20220122_120313_HDR (resized).jpg