Quoted from setzkor:For the flippers, you need both sets of numbers in the manual for the coils (one pair for each winding...in this case, I think the 34-4500 refers to the hold coil). The lower are J-25-500/34-4500, these are pretty common and available at Pinballlife etc. The top flipper coil is a J-25-600/34-4500 and is a little more difficult to source. When I redid mine, I left the original in place as it still worked. Also, many of these shipped with a 1 ohm 5W resistor in series with the top flipper coil, I replaced with a 1 ohm, 10W. Some may not have had it and you can adjust the EOS switch to lower the power on the top flipper if you think the plastics are in danger.
Talk to Terry, he can get whatever you need custom wound.