These look great. I haven't had the head off the snake. How are they being mounted?
You're currently viewing posts by Pinsider LP30.
Click here to go back to viewing the entire thread.
Quoted from Rickwh:OT: does the premium hammer really have an exposed screw like that? Or does it usually have a plastic cover over the screw head?
That's the way it comes. It looks better if you swap the washer for a black one.
Quoted from Tmezel:You may have to take out the top screw in the head and wiggle it a bit for clearance. Otherwise it just pushes in a clips onto another round plastic rod inside. Push and click. No software update needed.
Here's what he has said above
Took about 5 min to install on my METLE. I did have to loosen the screw on the top of the mouth a bit. They snapped right in after that, no Polident required. A great fit and they look very good. I played a couple of games and no problems. I hope they last. Thanks for the great effort.
You're currently viewing posts by Pinsider LP30.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/metallica-mod-snake-fangs-mezelmods?tu=LP30 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.