I've got a Medusa that has a flipper issue. Just on the left side. Started with the upper zipper intermittent then not flipping then the lower left stopped as well.
After a little investigation my tech savvy friend and I have determined there's power at all 4 lugs. Also the left flipper switch wire has continuity to the board.
We did find this broken wire. Does someone have a pic of their Medusa that shows where this goes correctly?
Also when the game starts, is the relay on that little board supposed to go on and off or stay on?

Thanks everyone as always![attachment=2531903,undefined caption="image.jpg"][attachment=2531903,undefined caption="image.jpg"]

image.jpgimage.jpg

Trying to upload again.
We did try reseating and checking the connectors were pined proper.
Also tested with new power board and MPU and same result. It's not a board problem. I have to look at switches or wires right?

Thanks Nighthawk128. I'd appreciate the picture for sure.

Thanks erak. I'll do that too. Still puzzling why I get no flip at all though on the left...

Thanks again Nighthawk128

Ok, New flipper issue...no flip on right side. Coils all have power and test fine. Transistors at the board all good. Fuses all good. I've been tracing wires until my eyes are blurry and still can't see a break or problem anywhere...Anyone have any other suggestions?