Hi all,

I have a medieval madness in for restoration. It was purchased partially torn apart but with all the bits. However there are a few parts that i need to get hold of and also clarify how some of the posts ect go on the playfield.

1. The first question is there was a hexagonal bottomed post behind the right troll target, is this correct and should it have the washer below?IMG_7978.JPG

2. There is a pointed piece of clear plastic riveted to a metal post at the rear right of the machine, should this have a washer directly under the nut or under the piece of metal fixing it to the post?IMG_7980.JPG

3. There are some machine screws with captive locking washers that hold the troll coil retainer in place, that are also used in other areas such as to hold the underside rails on and a few other items, I just need to order some as a few were missing from my game.IMG_7983.JPG

4. Where the coin box would usually be there is a metal bracket held by two machine screws to the wooden crossbar, this is missing on my game and instead has a piece of wood screwed with the wrong type of screws. I would like to find this metal bracket and the correct screws to make it right again if at all possible?IMG_7982.JPG

5. I would really like to find out which large metal posts go where at the rear of the playfield that hold the castle up and parts of the ramps, some had washers underneath and some didn't. If anyone has any images of where the posts locate and which ones have washers i would really appreciate it.IMG_7976.JPGIMG_7977.JPGIMG_7975.JPG

6. I have ordered a rubber kit for my game but some of the post rubbers clear the top of the screw hole meaning that they become squashed when a ramp or plastic is screwed down to them. The other version is shy by a bit more but i was wondering what is the correct rubber to install to make it factory. I hope this makes sense.

I have attached pictures for everything i have mentioned above and really appreciate your help in advance.

Many thanks

Harry

IMG_7979.jpg