(Topic ID: 180627)
You're currently viewing posts by Pinsider jake35.
Click here to go back to viewing the entire thread.
Quoted from perryd:check wiring, diodes, and cold solder joints on both of those switches. Could be cold solder joint or something wire coming
off one of the SW. Also check continuity from these switches going back to CPU board. Should be an easy fix.
perry
thanks. I'm going to have someone help me check it. I agree has to just be something loose as it was working fine and then just stopped. I ran the switch test and it won't move Frank.
Quoted from Kkuoppamaki:Do the switches work in switch test? I.e. if you trigger them by hand while in switch test will they show up on the DMD? If not, it's probably a loose wire but if yes check out this thread https://pinside.com/pinball/forum/topic/monster-bash-frank-updown-bank-tech
no the frank switches didn't work in the switch test, the dracula did but not Frank. Thanks
1 week later
Promoted items from Pinside Marketplace and Pinside Shops!
Bristow, VA
You're currently viewing posts by Pinsider jake35.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
