Hi Evey one,

I recently got a Maverick Machine that originated in Holland going by the start up screen and on the Power box in the cabinet. The plug on the machine is a stranded US 3 prong plug. I figured the person before me converted everything over to 110V. I have had the machine up and running and all but lots of burned out lights it all seems fine. On the power box it has 2 fuses and it says to use 5A Slo blow fuses. The Manual says for international machines it should have 2 4A slo blow fusees and for US machines it should have 1 8A slo blow fuse. I have read when going from 220v to 110 volt you should remove the 4 A and replace it with a 8 A. I also read some where the if the machine has 3 flippers to replace it with a 10A. I'll attach a pic of the wiring inside the box too in case it might help. It looks like each lead goes to a fuse then out, would this be the same as putting 1 fuse there with twice the amps and take the other one out?
GEDC0293_(resized).JPG

The Molex plug also looks like its wired as 100v The white wire is in the top middle hole and the jumpers are below it as well, I have attached a pic as well. I just wanted to make sure I should move the white wire and the jumper below it over. I couldn't fine where I can check the voltage at to see if this is actually 100 or 110.GEDC0296_(resized).JPG

Thanks in advance and sorry for the blurry pics.