I was playing a game and the right flipper just completely died. I have 45 volts on all 3 tabs. EOS switches were replaced a week ago and were working fine until now. Left flipper works fine. What should I be looking for?
You're currently viewing posts by Pinsider phillyfan64.
Click here to go back to viewing the entire thread.
I was playing a game and the right flipper just completely died. I have 45 volts on all 3 tabs. EOS switches were replaced a week ago and were working fine until now. Left flipper works fine. What should I be looking for?
It’s working now and I didn’t do anything except move the plunger in and out. The one diode seems to be giving different readings.
Ok thanks. The diode is reading the same now but I think you’re on to something about a coating on the switch contacts. When I compared it to the other flipper, it was reading as if the EOS was open ( I manually pushed the plunger to open it) when in fact it was closed. It’s making pretty solid contact so I will try a little sandpaper.
Quoted from Nikrox2:Remember - we love this game! lol Right?
Haha. Of course!
Quoted from BigAl56:Over time the solder connects to the relay and connector pins on the sol driver board go cold causing erratic problems like this. If it happens again pull that board out and reflow those connections if you haven't already done so.
It’s a newer Alltek board but I get your point. I should probably repin those connectors. The solder connections at the coil itself don’t look too great either.
You're currently viewing posts by Pinsider phillyfan64.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/mata-hari-dead-right-flipper?tu=phillyfan64 and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.