in most cases this kind of problem is typically caused by the rubber ring located behind the targets
You're currently viewing posts by Pinsider creepykenny.
Click here to go back to viewing the entire thread.
in most cases this kind of problem is typically caused by the rubber ring located behind the targets
either too thick or stretched with tension on opposite side of targets making the target side of the rubber looser than it should be causing the targets to rebound off the rubber when hit and not actually drop
from your pictures above, to me it looks like you have the incorrect style of drop targets installed - those appear to be the "hooded" type (which are for in-line drop targets where the ball has to roll over the target when its in the down position) when you really just need to use the "tombstone" style which are skinnier/thinner and will fix you right up!
and for all others with similar problems ..... one thing of note when replacing original drop targets with new ones is that many times the new ones have a slight curve to them where the originals were completely straight, they should be straight / flat
if yours are curved they can be straightened by heating and bending them - i have done this by dipping the curved ones in boiling water bend straight & drop in cold water
not saying this is your problem (you have wrong style of drop installed), just saying i have seen it in almost every instance of new target replacement
for all others to trouble shoot this problem you would pull the rubber rings behind the targets off and see if your drops fall correctly, if not, then loosen the drop assembly and see if it will slide forward and try again
You're currently viewing posts by Pinsider creepykenny.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/mata-hari-another-bally-drop-target-brick-problem-?tu=creepykenny and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.