X-Men (LE)
Stern, 2012You're currently viewing posts by Pinsider AvidPinPlayer.
Click here to go back to viewing the entire thread.
Hi everyone. I have a problem with my Wolverine LE in that the Magneto magnet and its spinning disk is not activated when Magneto releases the captured balls during multi-ball. It used to do it fine until last week. The spinning disk works fine all other times. All connections are good. I'm running V1.51. Planning to re-install the code just in case.
Any other troubleshooting suggestions?
Quoted from coz6:Do your night crawlers work- In coil test just wondering if you got hit with the aux board issue
Yes, they work fine. It is a relatively new pin and the dealer informed me about the replacement of the auxiliary board.
You're currently viewing posts by Pinsider AvidPinPlayer.
Click here to go back to viewing the entire thread.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/magneto-magnet-and-spinning-disk-not-working-properly?tu=AvidPinPlayer and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Odessa, FL