OP

Quoted from nzman:

Hi all...
I'm having a weird problem.
Some of the lights won't light up on my Terminator 2 Pin.
It's quite a few lamps.
When I did some investigating, I realized that the lamps were all from 2 different cross sections of the lamp matrix.
Row 3 / Col 3
Row 8 / Col 8
Row 3/ Col 3 lands on the (leftside) target 3. I replaced the resistor on that lamp, which makes me think I have the incorrect resistor in there. Anyone know the correct resistor for this circuit board ? (board A-14517 5768-12790-00 see attached) The best I can see on the other resistors is that they say "N1" on them.
Row 8/ Col 8 lands on Top Lane Right light. I haven't touched that lamp. (besides replacing all bulbs with LED lights)
Any ideas on fixing these issues ?
thanks in advance[quoted image]