Hi guys, I'm in hopes someone can snap a pic and post if for me... one of two machines I brought home last week and this one has a burned board... well seems they cut the connector off, installed a power supply and wired the back box lights to that... ordered the board, re pinned the wires for a connector, but looking at the manual... I have an extra white/ yellow wire.

okay so I have the wires with new ends ready to plug into the connector... I need someone to check me on this as well.
according to the manual, see pic... the wires I have separated to the right have voltage... will these be my input? I was thinking yes

also, and this is the biggest thing... I have 9 wires and only 8 pins on the board. that's why I need a pic.
I have 3 white/ yellow wires... the schematic only shows landing for 2 of each color.

if you need more info or pics just let me know... thanks in advance for the input

manual page 45 first yellow sheet (PPB Board) top right on the page... (J5) connector--- bottom left board in the machine lol

IMG_1080[1] (resized).JPG

IMG_1081[1] (resized).JPG

okay so I removed all this from the coin door area... wires to the back box door along with the power supply...
re- pinned the connector minus the 2 white/ yellow wires ???
and am fixing this other burn connector that had a wire cut from it, twisted together and shrink wrapped...

IMG_1082[1] (resized).JPG

IMG_1083[1] (resized).JPG

IMG_1084[1] (resized).JPG

so I just found this little gem at the power supply board, and I have to wonder if my white/ yellow wire was like this yellow wire is and he basically hut the wire in half lol

IMG_1085[1] (resized).JPG

exactly, pins 1,2,3, and 4 from bottom photo to the top of photo are the "hot" ones traced the other end from the back box so they are in the right spot
thank you for the post

yup looks like that one yellow wire on 5 is one wire... he cut both ends off hahahaha

AWESOME thanks again for the input