Would love to know how to break that roll down & use for undercab ect... Anyone got a video?
(Topic ID: 176766)
You're currently viewing posts by Pinsider Butch2099.
Click here to go back to viewing the entire thread.
Quoted from Travish:It's easy just alcohol wipe to give a good clean area and roll/stick it on starting at one end and cut with scissors where it ends. You can plug the power into the tech jack inside the cabinet if you don't have a splitter. If you have bigger pieces of leftover you can solder wires directly on the pads and use them too for drain holes and shooter lanes if you like those.
I have undercab lighting on a few of my machines, so I'm familiar with that. I wouls need more instruction on what I need to make my own. Say I cut a strip, how does it get attached to that plug & then the connector? Do they sell those parts separately & how hard is it to do? I suck at soldering.
You're currently viewing posts by Pinsider Butch2099.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
