So the primary shot coil stopped working (this was replaced maybe 2 years ago) it would try to shoot the ball weakly then it wouldn't try at all. This happened in a span of 5 minutes (was previously working fine). THen I noticed all the coils in that line weren't working either, right flipper, left flipper, VUK, Ripper whole and so on. Cabling looked ok, and all fused tested fine (in circuit) I noticed that the CN1 connector was a little toasty so I pulled it and one of the pins from the PS board came off with the molex. Reflowed the pin and its in there pretty strong now. Doesn't seem to of fixed the issue. Any thoughts?