Does anyone have an extra Blue Lagoon ramp I could use to make a mold from? It can be somewhat broken...if all the pieces are there, even better. I know where I can get an intact one, but I would rather not take that one out of the machine if I can help it. I should have the main ramp for LAH available late Jan-early February.

Found a Blue Lagoon donor...thank you everyone for the speedy offers of help, I couldn't do it without you guys! I am going to try to include as much of the riveted stuff as I can find for this, so reinstalling will be a bit easier. There is a lot attached to this guy, but I can also do a cheaper bare option if you want to DIY the whole swap.

LAH test pull is done...Blue Lagoon ramp will be getting some attention next week. Stay tuned! The other ramp is BTTF.

20230114_124952 (resized).jpg

I make a lot of ramps...you can check them out at www.rampomatic.com. This ramp along with the Blue Lagoon ramp should be available for purchase in February.

They they sure are starting to stack up in here

Note on the Lagoon ramp...the metal bits are actually pretty specialized on this, like the special switch bracket with the coil stop and the wire terminal block...so I will not be able to include them. I will offer to remove and rivet your pieces on to the new ramp for a small fee though, should you not be comfortable riveting them yourself.

20230119_210134 (resized).jpg

NOTE: I am not selling toppers directly through my store, they will be sold exclusively through Marco Specialties. Here are some samples of the upcoming Last Action Hero topper and tar pit ramp. The main ramp is available now at www.rampomatic.com.
The Tar pit ramp turned out great...the wave on the bottom of the middle section is due to a processing error on my part for the test pull. I had to jump up to .187" thick material, as .125" was too flimsy...so the price will be a little more expensive as a result.

20230122_154517 (resized).jpg

20230122_155055 (resized).jpg

I have been seeing this pop up several times in the last week...I need to open a support ticket and see what is going on.

I have a handful more tar pit ramps available on my site...then it will be about 2 weeks until I have any more available.

To clear up any confusion on the toppers...the original is vacuum formed, as are the ones I am making. I am using 3/16" plastic because the draw is so deep, it adds rigidity to the top of the lens, where the plastic stretches the most. New plastic is also much less brittle than 30 year old plastic, so you should not have to worry about them being as fragile as OEM pieces.

Marco is providing the decal plaque (it is screwed into the front of the topper, as original) for me to install on the finished toppers. I am currently still making the toppers and will be shipping them to Marco when complete.

Marco ordered a large quantity of them, so it has been taking me a while to get them all done. The large quantity means these are going to be pretty affordable. I know everyone would like to have them yesterday, but patience will pay off, I promise. And yes, these are a Marco exclusive, I will not be selling any of them directly.

Hoping to get these shipped off this week if all goes well. The plaques turned out beautifully as well.

20230326_172036 (resized).jpg

20230326_182938 (resized).jpg