I'm hoping someone can help me out with a couple assembly questions. I'm helping with a Laser War project pin, but it has had some key elements parted out, and I've not been able to identify everything needed in the IPDB manual. Two elements in particular:

1) An assembly for the left kick-back (aka Laser Kick); and

2) What the proper spinners are (with assembly).

Of course, viable substitute suggestions are welcome as well if something perfect is no longer available. Thanks!

Thanks, found a part listing that suggested similar, so we'll go that route.

Just the spinner assembly to figure out now (I'm assuming both spinners are the same set-up).

I was wrong, the spinner brackets are different. These are the numbers from the manual, but I've not found reference (at Marco's or elsewhere) to acceptable substitutes. Not sure if there are any. Bracket numbers:
535-5213-01
535-5213-02

Another question, Marco's plastics set has two blank pieces (about 7.75" x 4.5"). Not sure where those go. The double-stacked ones to provide support?

I did have an area collector confirm the left and right bracket are the same size, just the mounting is different (hence the different part number).

The right spinner bracket is actually now at an area machinist shop, to have them just make a left-side one based off the dimensions. It seemed to be the easiest way to tackle the problem.

The custom-shopped spinner bracket worked. Game is all finished.