Last Action Hero
Data East, 1993Hi,
The LAH I have purchased has no gun nor automatic shooter. These part were replaced by simple manual shooter. It means that the multiball is not operational.
I purchased the launch assembly but I do not know how it must be connected. There are 2 wires, one brown, one yellow. Where are they going to ? A pic or some indications would help
Thank you
B0C6FB5C-F1AD-4119-8AC5-4DE04F83AA4A (resized).jpegYellow (banded side of the diode) should connect to the Yellow-Violet wire.
The brown wire (non-banded side of the diode) should connect to the Violet-Orange wire.
Tech Chart might come in handy too....
http://www.pinballrebel.com/pinball/cards/Tech_Charts/Data_East_Last_Action_Hero_Tech_Chart.pdf
Peter
http://www.inkochnito.nl
I don't think so, but I can be wroung.
Is there something under the apron?
Most of the time there are just two lose wires....
From the looks of the image on the ipdb it doesn't have any connector.
https://www.ipdb.org/showpic.pl?id=1416&picno=10109
Just remove the wires and connect the original wires.
Wanna join the discussion? Please sign in to reply to this topic.
Great to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
This page was printed from https://pinside.com/pinball/forum/topic/ladt-action-hero-info-needed-about-the-ball-shooter- and we tried optimising it for printing. Some page elements may have been deliberately hidden.
Scan the QR code on the left to jump to the URL this document was printed from.
Étalle
Piershil
York, SC