New! Dark mode!

Browsing Pinside at night? Getting tired of all the white? Switch to dark mode using the button in the top right (or CTRL-B)!

(Topic ID: 137708)

Kiss Rectifier Board (as-2518-49)


By troxel

5 years ago



Topic Stats

  • 11 posts
  • 5 Pinsiders participating
  • Latest reply 2 years ago by wizard_mode
  • Topic is favorited by 1 Pinsider

You

Linked Games

You're currently viewing posts by Pinsider lindsey.
Click here to go back to viewing the entire thread.

#4 5 years ago
Quoted from barakandl:

It is worth checking that the transformer tap is set for 110/120v.

That is the first thing I would look at. Assuming those are true voltage readings, they`re not even close to where they should be. Even unloaded. Usually the reading will be higher without load. Those readings are way low.

TP3 is the only one which is correct, which is weird. If the mains are connected to the wrong winding on the transformer, all of the readings should be out by the same ratio.

Also ensure that your voltmeter batteries are good and you`re getting good measurements

#8 5 years ago
Quoted from barakandl:

Lower end DMMs have trouble reading a circuit with no load.

That`s not really going to be an issue with linear power supplies in a pinball machine. Even the crappiest meter should still get you in the ballpark.

If your meter is giving you those kinds of reading from a known good rectifier board, its time to throw that meter in garbage

There`s an example of checking the rectifier board test points in this video at 4:30.

#10 5 years ago
Quoted from barakandl:

What ballgame we playing. Check with a fluke. I can guarantee the high voltage will read like 60v too low. That is 30% off. The only ones you can trust is the dc voltages with the load resistors. Check with a cheap meter, and it gets even further off.

You're definitely right about the HV. I always thought that was weird when I first started working on Bally stuff.

If only the high voltage was showing a weird number then you would have a point. That was not the case, so the quality of the meter isn't really relevant. Like I said, the crappiest meter will get you in the ballpark of what are known to be good voltages for this board without load. Even the high voltage. The voltages posted are not even close, so which meter you're using isn't relevant. Unless its totally boned, which I already mentioned.

The point is that the voltages produced by an unloaded Bally rectifier board are well known and even the shittiest meter would not be off as far as what the OP reported.

I don't think anyone is denying that the HV reads weird unloaded. But the weirdness is consistent and predictable.

EDIT: To be clear, when I said "If your meter is giving you those kinds of readings with a known good rectifier" I was referring to the readings posted by the OP. I'll stand by that. If a Fluke is giving you normal readings and another meter with good batteries is giving you THOSE readings then your meter is broken.

Promoted items from the Pinside Marketplace
$ 85.00
From: $ 45.00
Displays
PinballSolutions.eu
From: $ 25.00
Boards
nvram.weebly.com
$ 103.00
$ 50.00
$ 22.50
$ 9.00
Cabinet Parts
Third Coast Pinball
From: $ 155.00

You're currently viewing posts by Pinsider lindsey.
Click here to go back to viewing the entire thread.

Hey there! Got a moment?

Great to see you're enjoying Pinside! Did you know Pinside is able to run thanks to donations from our visitors? Please donate to Pinside, support the site and get anext to your username to show for it! Donate to Pinside