Hopkins, MN
I'd put a meter on your feature lamp power source and see if it's high or right.
Then you'd know power issue or crappy bulbs.
LTG : )™
(Topic ID: 145520)
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Quoted from MaxPinball:please give me a little more detail on what/where you mean?
Dig out manual/schematic. Feature lamp power is leaving a board and going to the sockets. You'll need to figure the connector on what board and measure at the connector.
LTG : )™
Promoted items from Pinside Marketplace and Pinside Shops!
You're currently viewing posts by Pinsider ltg.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
