Columbus, IN
That is Martin from pinbits in the video.
Great job!
(Topic ID: 9608)
You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
Did it with my 40 watt iron. The part I found most difficult was removing the burnt resistor. Everytime I'd heat up the back side, id drop the iron and grab my pliers to grab the resistor and pull, but by that time it would have cooled off. Those helping hand clips must be pretty helpful.
That is why you have 2 hands 
Set the board on the bench, or use a vise.
I use one of these.. if you find yourself doing a lot of board work, you may want one. I have an expansion bar so I can put a board as big as a WPC power driver board in it. The base is weighted so it won't tip over.
You're currently viewing posts by Pinsider johnwartjr.
Click here to go back to viewing the entire thread.
Reply
Wanna join the discussion? Please sign in to reply to this topic.
Hey there! Welcome to Pinside!
Donate to PinsideGreat to see you're enjoying Pinside! Did you know Pinside is able to run without any 3rd-party banners or ads, thanks to the support from our visitors? Please consider a donation to Pinside and get anext to your username to show for it! Or better yet, subscribe to Pinside+!
