I wanted to thank Mike and everyone in this thread with the rotisserie instructions and ideas!
I made the saw horse / table top version yesterday and wanted to share pictures and costs.
Everything was purchased at Menards, they were out of the black pipe so I went with the galvanized steel which was a bit cheaper - except the T connector I used the black ones.
Part list and costs:
2 Angled irons 2 ft long - $5.63 each
2 12" galvanized steel pipe - $1.89 each
2 Caps - $0.69 each
2 1/4" by 3" eyebolt with nut - $0.49 each
2 1/2" by 5" pipe - $0.79 each
4 flanges - $2.96 each
2 3/4 x 3/4 x 1/2 T connectors $2.49 each
I also bought the 1/4 tap with bit for $5.28 and a tap wrench for $3.98
total cost at Menards - $45.06 plus tax
Parts I had on hand were the saw horse, scrap 2X4, 2 C clamps and 1 and 1/2 carriage bolts and nuts (which are longer than necessary if buying go with 1"
Also the 5" pipe is too long but they didnt have and 4" if you can find 4" that is the correct size.
Also, I was able to use bolts to attach the pf to the angle iron, if it doesn't workout then you'll need 4 more clamps