Is transformer wiring correct, the commion power is going to transformer but the black power cord wire is going to a 5 a fuse block shouldn’t black cord wire go to transformer, on the transformer their is a vacant spot that says high, machine has been in somebody’s basement and they had no knowledge of machine or history but it does not look like original cord

16B0E084-C454-4A36-9F4C-C322245A1AA6 (resized).jpeg

61CA5082-AE4A-4605-9AAE-CC2DF2E2D34D (resized).jpeg

987A3735-1BDD-4C7E-9EC8-E86D6ABBDC16 (resized).jpeg

Majorettes

Yes I have multimeters I am a hvac tech I have 110 c when plugged into outlet but no voltage anywhere else I thing somebody must have wires power cord wrong

I am in Toronto canada

Checked fuses all good, tried with flipper , I don’t have 110 at transformer

Are the bottom 2 wires the primary voltage 110v

image (resized).jpg

hey thanks for your help i followed wire to front on machine will send pic i have 11o voltage at this spot

Then wires go to door

Wire from fuse terminal goes to door I have 110 volt at white and black wire the two other wire do u bypass any wire , their is a oeange and blue wire that goes in coin mechanism, I tried coins not working can I bypass any of the wires?

image (resized).jpg

thanks going to order schematic ,which relays start the machine i will post pics from phone the power cord is no good but i am using my test cord that i use to start furnace and ac motors are pinball machines ground sensitve?, i have 110 volt at the door switch and does the two wires at coin mechansim can i bypass them

I know it’s missing the tilt thing which way should this be up or down?

461CF580-2E29-480E-BBC3-E2E2E3513E14 (resized).jpeg

black and white wire were on a door switch and red and blue to coin slot mechanism 110 volt at white wire I tried putting black and white together and red and blue and tried with one off and other on no luck

image (resized).jpg

The 4 wires goes to this junction box only white again is power at this box tried touching flipper relay when I bypassed the door wires

image (resized).jpg

What is this I have 110 volt to this also

image (resized).jpg

Maybe I have to bang on wood I have fixed many things with a tap of screw driver and sometimes even a kick lol

, no luck i tried jumper door switch and start switch nothing going on wont start , would love to hear a bell or see a light, cant sleep

Well I touched this switch lights came on and bells and lovely noise but the score counter, ball knockouts and bells just kept going flippers work bumpers work but machine just keeps going until I take off jumper wires to door switch

image (resized).jpg

Thanks so the door switch wires I should just put together then release

the machine just keeps running i have ordered schematic and lights and rubber, could a contact be stuck close in the reels it wont reset, it only keeps running when i put the black and white door switch wires together the red amd blue wires to coin mechanism doesnt seem to do anything, i am being a bit impatient but i am a nut when i cant figure things out but i will and thanks to this great forum, i read that it could be the reset relay i tried playting with that machine just keeps running and score reels just keep going

they just keep spinning

tried bypassing wire to coin mechanism

all of the reals just keep going forever none of them stopo at zero

well thanks for all your guys help and info i have most things sorted out, my right flipper is weaker i tried playing with my swithces i was thinking about getting new solenoid, i read many threads about this problem, was going to swap out solenoid , from the other side, but right flipper is working great dont wont to mess with it,would taking apart solenoid and cleaning help