My premium, built 3/20/20, had a spinner that wasn't registering. I bent the spinner wire to get it to push further on the switch leaf, but no luck. I could have bent it more, but didn't want to mess up a smooth spin.

I Took it out and bent the leaf. Works great now. I probably could have done this without removing the switch, but removing it wasn't too bad, and allowed for precision bending. This technique also filled up some unemployment time. There was no screw that could be adjusted as mentioned in post 3324. Loving the spitter sound effect now!

20200408_184817 (resized).jpg

I couldn't find anything about that adjustment in the forums. What do the two screws do? Looked to me like the screws just held the switch together.

You can also pull out the interlock switch which sets it to "door closed" mode

Thank you! Will definitely be on the machine when friends finally come over. Every day use, not so much

20200516_180018 (resized).jpg

Mine was registering never, I fixed it by bending the leaflet. Has worked perfectly since. Some posts about a screw you can adjust, but I took out the switch and couldn't find an adjustment screw.

I'm not sure if it is normal or not, but mine does this also. Even if I adjust the middle position bias, she always drops down a little to my left