Quoted from DeathHimself:

Does anyone know if the new JP's are coming with the newer node boards like GOTG? I ask for I would assume that the Ultimate Code would no longer be abled to be installed on them just as the did with Pinball Browser and Cleland code for GOTG in their V1.08.
Maybe Sterns shrewd way of counteracting people for making modifications to the code on their own, who knows.

Quoted from Flynnyfalcon:

Can anyone offer any suggestions?
My upper flipper is starting to intermittently fail? I've reflowed the coil connectors along with the switch. The lower flippers are perfect. It'll fire sometimes, half fire other times, but mostly not at all.

Quoted from dnapac:

I was supposed to be picking up my JP Prem tomorrow…but my distro only received a 1/4 of his order. He got 2 and I’m number 3. Shortages everywhere causing tons of delays. At least I have Halloween to pick up soon!

Quoted from dnapac:

Is your distro pinballpro? Enjoy JP!

Quoted from dnapac:

Yup. We were down to his business to try out some pins a couple years ago. Great guy. I’m bummed but can’t complain since I’ll soon have Halloween. Just have to wait for JP. Gives me time to figure out the mods and adjustments that are best.

Quoted from cait001:

do I need to get a deeper socket wrench to remove this post?
[quoted image]
It's easy to remove the nut on the back of the playfield, but I can't on top with my current nut driver, and I can't get at this with a wrench unless I tear apart the right side of the playfield.

Quoted from bdaddy:

Not to mention, by the time you are good enough to "finish" the game by completing all the modes, including "when dinosaurs ruled the earth", you are doing things like trying to beat your high scores, not so much focused on finishing the game modes or completing the game.

Quoted from seenev:

Any updates on when the new topper run is expected? Seems like it's been delayed forever.

Quoted from CashMoney:

Yeah I knew it had to be cheaper than $1k… SMH.

Quoted from Flash71:

Where did you get the jeep upgrade? Can’t seem to locate one. Thanks!

Quoted from Markharris2000:

The 1:43 version is getting VERY hard to find. Lots of 1:32 and a few 1:24, but hard to find the 1:43 version... keep looking as they do come up from time to time.

Quoted from Manny65:

I assume you mean the left (T-Rex) ramp? As the right ramp (with the spiral wireform) and the Heli ramp have micro-switches (not optos).
The entrance opto on the left ramp now has a modified left ramp protector that addressed fast balls not being detected - so if you have an early Pro or LE, this might help you (alternatively you can place a piece of tape over the low half of the opto hole). This reason is that the faster balls have a tendency to get more air on the ramp such that the ball doesn't break the lower part of the opto beam.
There is also an opto at the back of the left ramp (behind the backboard). The more recent machines off the factory floor people have reported that this back opto has been misaligned and needs the above tape technique or some adjusting

Quoted from JMCFAN:

ebay.com link: itm

Quoted from WaddleJrJr:

Yeah it's the one in the T-Rex ramp behind the game, I just took it off and reflowed the solder too it, agree it was a pain to get to, that didn't fix it unfortunately so sounds like I will have to get it replaced. I believe my game has the mentioned ramp protector on it already.
I'll try the tape technique though, so piece of black tape that covers the bottom half of the hole in the ramp?