Quoted from Galvez1978:
I just buy the JP Premium and the shaker motor, but i do not received yet, you know it are any tutorial for install it? Regards?
Two things I suggest when you are ready to install the shaker motor:
1) get some nylon cable tie-wraps and tie the wiring to the existing wires that run from right to left behind the cash box. It will make the installation much cleaner and prevent any tugging on those cables accidently if you pull the cashbox out. I used 5 tie-wraps.
2) get some BLUE thread-lock liquid. Harbor Frieght sells both RED and BLUE for $2 a bottle. Get the BLUE and put a drop on each thread before you screw the four screws into the cabinet mounted T-Nuts. (Blue is the medium strength, semi-permanent type)
Note1: The Premium is pre-drilled and T-Nuts installed, but not very consistently. I would use a small hammer and tap each of the T-Nuts into the cabinet from underneath before you try and install the shaker motor screws from up top. The provided longer screws that go through the cabinet are 'just' long enough if the T-Nuts are tapped in properly.
Note2: The two self-threading hex cap screws that hold the plastic cover on will be a challenge to get installed, but they WILL work! The brackets are somewhat moveable with some pressure, so just stay at it and it will thread with enough energy applied! Get the first one in, and then push/tug/press the cover front to back to front to meet the second hold and press hard when it starts to line up!