Quoted from gunnermac:Hi Maniac, yes I did that thanks.
I've just replaced the EOS and checked the voltages on that coil. When I go into Diagnostics and the coil gets activated it gets a constant 4volts? This is wrong and should only hold that when the flipper button is pressed and the EOS is open - what could be the issue? The EOS is closed, so by rights if it was getting constant power it should be 20volts to get the high power so it just doesn't make sense that it only has 4. Could it be the flipper leaf switch gone and constantly open?
Could you give me some pointers on how to check why its got 4 volts?
Stu
I have had a FLP023 where the dip switch was mounted wrong. So the on-position was where it said 0 on the PCB.
I had to reverse the settings - instead of 001001 I had to set it as 110110 as indicated on the PCB.