Installing and lighting a replacement magic bus:
Swapped the bus out for the "old friends" model. Used the existing bracket with no modifications so go back to original at anytime.
Remove the blue rubber bus and take off the metal bracket. Open the new bus (2 philips screws). Tape the window plastic in place with aluminum tape which helps with the lighting and also baffles the light from shining up and out the roof. Mount a blue (or other color) led strip inside the model.
Then sandwich the model over the metal bracket and put the 2 screws back into the model. Nice and snug. No glue or anything else is needed to hold it.
The wires from the blue led strip come out by the right back tire. Zip tie them to the metal bracket and drop down and existing hole in the playfield. Then Install the assembly back on the playfield.
Use aligator clips to attach to any GI light to keep it lit full time.
I'm going to end up attaching it to the magic bus diverter though so it only lights during magic bus mode. Need to figure out what if any resistors to add to the leds don't blow out.
20170513_153405 (resized).jpg
20170513_153442 (resized).jpg
20170513_153448 (resized).jpg
20170513_153609 (resized).jpg